13sharkclean.co.uk12 sharkclean.co.uk
NOTE: All accessories are compatible with both the wand and the handle�
OPERATING THE VACUUM
CLEANING MODES
To engage brush-rolls, step on floorhead and
tilt handle back�
Press the Wand Release button to detach the
wand from the pod�
With pod removed, press the Wand Release
button to detach the wand from the
floorhead�
Press the Handle Release latch to detach the
handle from the wand�
Press the Powered Lift-Away button to
detach the pod from the floorhead�
UPRIGHT
ABOVE-FLOOR—HANDLE
POWERED LIFT-AWAY®
ABOVE-FLOOR—WAND
LIFT-AWAY®
OPERATING THE VACUUM
SETTINGS
NOTE: Try using Hard Floor mode for low pile area rugs�
WHAT DO THE HEADLIGHT INDICATOR LIGHTS MEAN?
Solid White Lights: The brushrolls are spinning and unit is working as it should�
Solid Red Lights: There is a jam in the brushroll area� Turn o the vacuum and unplug it, then
remove any blockages in the floorhead�
Flashing Red Lights: The motorised floorhead is overheating� Turn o the vacuum, unplug
it, and remove any blockages� Let the vacuum cool down for at least 60 minutes before
restarting� See Troubleshooting section for more information�
Flashing White Lights: The vacuum is operating in an environment that is either too hot or too
cold� This vacuum will only function properly in temperatures ranging from 0°C (32°F) to 40°C
(104°F)� Turn the vacuum o and adjust the room temperature�
HEADLIGHT INDICATOR LIGHTS
HEADLIGHTS
The headlights will flash or turn red to
indicate issues that need attention�
Press power button to turn on vacuum� Please
note the brush-rolls will not spin until you
have stepped on the floorhead and tilted the
handle back�
Thick Carpet & Area Rug Cleaning
Slide the surface switch to the top position
to select Thick Carpet/Area Rug�
Carpet & Low Pile Cleaning
Slide the surface switch to the middle position
to select Carpet/Low Pile to increase the
speed of the brushrolls and to help remove
stuck-on dust and debris�
Hard Floor Cleaning
Slide the surface switch to the bottom
position to select Hard Floor�
POWER SWITCH
SURFACE SELECTOR
NOTE: Try using Hard Floor mode for low pile area rugs�
To Next Page
Loading...
Need help?
General
