Why is my Shark DD-232336 spray wand leaking?
If your Shark Pressure Washer spray wand is leaking, it might not be properly attached (slide the spray wand into the gun and turn the wand collar clockwise onto the spray gun threads until tight).
Why won't my Shark DD-232336 Pressure Washer engine start?
If your Shark Pressure Washer engine won't start, possible causes include low oil shutdown (fill engine with oil), being out of gas (fill fuel tank), or water in the gasoline (drain gas tank and fill with clean fuel).
Why is the garden hose connection leaking on my Shark DD-232336 Pressure Washer?
If the garden hose connection on your Shark Pressure Washer is leaking, it could be due to loose fittings (tighten the fittings) or a missing/worn rubber washer (insert a new washer).
Why is water leaking from the pump protector of my Shark DD-232336 Pressure Washer?
Water leaking from the pump protector of your Shark Pressure Washer can occur if the spray gun is closed with the machine running for 5 minutes or longer (open the spray gun or turn off the machine), or if there is excessive water supply pressure (place a pressure regulator at the end of the 50' garden hose).
What causes low pressure after normal use of my Shark Pressure Washer?
If the pressure is low on your Shark Pressure Washer after a period of normal use, the nozzle may be worn (replace the nozzle).
Why does my Shark DD-232336 engine lack power?
If your Shark Pressure Washer engine lacks power, the air filter may be dirty. Replace the air filter.
Why is the engine on my Shark DD-232336 overloaded?
The engine of your Shark Pressure Washer might be overloaded because the nozzle is partially blocked (clean the nozzle) or there's excessive pressure from high engine RPM (adjust the engine throttle to lower RPM).
What to do if my Shark Pressure Washer engine operates for 15 minutes then stops?
If your Shark Pressure Washer engine operates for 15 minutes and then stops, it might be caused by not enough gas or engine oil (fill the tank with gas and check the oil level), vapor lock developed by the heat of the day (keep the gas tank full to avoid vapor locking), or an obstruction in the fuel filter (clean or replace the fuel filter).
Why does my Shark Pressure Washer have fluctuating pressure?
Fluctuating pressure in your Shark Pressure Washer could be due to several reasons: * The nozzle is obstructed (blow out or remove debris with a fine needle). * The pump is sucking air, or the inlet hose is leaking (check that all hoses and fittings are airtight, then turn off the machine and trigger the spray gun until a steady flow of water emerges through the nozzle). * There is insufficient water supply (turn the water on full force and check the garden hose for kinks, leaks, or blockages).
Why is my Shark Pressure Washer not dispensing detergent?
If your Shark Pressure Washer is not dispensing detergent, consider these possibilities: * The detergent suction tube isn't properly connected (check the connection). * The detergent is too thick (dilute it, or use the manufacturer's detergent for best results). * The detergent filter valve is at the lowest setting (set it to a higher setting). * The filter on the detergent suction tube is clogged (run warm water through it to remove debris). * The detergent suction tube is damaged or clogged (remove the obstruction or replace the tube). * A high-pressure nozzle is attached (replace it with a black detergent nozzle). * The discharge nozzle is obstructed (blow out or remove debris with a fine needle).
General| Brand | Shark |
|---|---|
| Model | DD-232336 |
| Category | Pressure Washer |
| Language | English |
To Next Page
