sharkclean.comsharkclean.com
MAINTENANCE
CLEANING AND REPLACING THE FILTER
Remove and empty the dust bin. Clean any hair or
debris o the Anti-Tangle Comb on the back of
the dust bin.
Pull filter out of the dust bin by the tabs.
Lightly tap the filter to remove dust and debris. Reinsert the filter into the dust bin, then slide the
dust bin back into the robot.
For optimal suction power, regularly clean and replace the filter inside the robot's dust bin.
See sharkaccessories.com for replacement filters.
IMPORTANT: DO NOT use water when cleaning the filter.
SELF-CLEANING BRUSHROLL
MAINTENANCE
To access the brushroll, push up on the tabs on the
brushroll access door, then lift o the door.
The Self-Cleaning Brushroll actively removes hair wrap while your robot cleans. If some debris remains
wrapped around the brushroll, continue cleaning to allow the brushroll to clean itself.
Lift out the brushroll. Clean o any debris from the
brush roll.
Reinstall the brushroll, inserting the flat end first.
Close the brushroll access door and press down until
both sides click into place.
NOTE: Replace brushroll every 6 to 12 months, or when visibly worn. See sharkaccessories.com for replacement parts.
NOTE: When cutting away debris, be sure not to cut the brushroll.
NOTE: Make sure to insert the dust bin completely, until it clicks into place.
To Next Page
Loading...
Need help?
General
