TOLL FREE: 1-800-798-7398
STEAM CLEANING
4 For your comfort, you can adjust
the height of the mop. Just lift
the latch on the tube 90 degrees
to the open position. Holding the
handle, extend the tube to the
desired height and then close the
latch to the locked position.
5 Plug in the mop. Wait 30
seconds for the unit to heat up
and the steam to be ready.
Push the handle toward the
mop head in a pumping motion.
Customize steam output by slow
or fast mopping with a forward
and backward motion. (fig. 4)
Quick Start
www.sharkclean.com
fig. 4
QUICK TIP:
For easier
pushing
and pulling,
extend the
handle length.
NOTE: Do not leave your
Steam Mop unattended
during use.
IMPORTANT: Never leave
the steam mop in one spot
for any period of time with
a damp or wet micro-fiber
pocket attached as this will
damage your floors.
S3251_11_ENG_IB_101117.indd 5 10-11-17 1:58 PM
To Next Page
Loading...
Need help?
General
