sharkclean.comsharkclean.com
NOTE: All accessories are compatible with both the wand and the handle.NOTE: For deep carpet cleaning per ASTM F608 (embedded dirt in carpets), set to MAX suction and use setting II, Carpet.
WHOLE-HOME CLEANING
CLEANING MODES
Press the Power/Surface switch to the
appropriate floor setting, then step on
the nozzle and tilt the handle back to
engage the brushroll.
Select surface setting:
O O
I Hard Floor
For bare floors and area rugs. The brushroll will
spin slowly in this mode.
II Carpet
For carpets. The brushroll will spin quickly in this
mode.
To engage the brushrolls, turn on the power,
step on the floor nozzle, and tilt the handle back.
WHAT DOES THE BRUSHROLL INDICATOR LIGHT MEAN?
Solid Green: The brushroll is spinning and working as intended.
Solid Red: There is a jam in the brushroll area. Turn your vacuum o, unplug from the wall and
remove any blockages in the nozzle.
Flashing Red: The motorized floor nozzle is overheating. Turn your vacuum o and wait a
minimum of 60 minutes for it to cool down.
See Troubleshooting section for more information.
Press the Wand Release button and pull up
on the wand to detach it from the pod.
Press the Handle Release button and pull
up on the handle to detach it from the wand.
UPRIGHT MODE
POWER/SURFACE SWITCH
INDICATOR LIGHT
ABOVE-FLOOR—WANDABOVE-FLOOR—HANDLE
Handle
WHOLE-HOME CLEANING
SETTINGS
BRUSHROLL INDICATOR LIGHT
The Suction Control Slider located on the handle
allows you to adjust the suction depending on the
floor type.
MIN: to reduce suction and increase
maneuverability on carpets.
MAX: to increase suction on bare floors.
SUCTION CONTROL