sharkclean.comsharkclean.com
EMPTYING THE DUST CUP
To remove Dust Cup, slide up the release button
on the dust cup handle. Tilt dust cup forward,
then lift to remove.
To reinstall, place bottom of dust cup into
pod and then tilt back until it clicks into
place..
Press lower release button to open bottom of
dust cup.
To remove collected debris from Lint Screen,
press top release button and lift handle to
open. Gently brush lint screen to clean.
CLEAN HEPA FILTER
EVERY YEAR
Remove dust cup, tilt Filter Door and firmly
pull it o. Press tab at top of HEPA Filter and
pull out filter. To reinstall, insert HEPA filter
into unit and replace the filter door.
CLEAN PRE-MOTOR FILTERS
EVERY MONTH
Remove Dust Cup, then lift out Filters.
Regularly rinse and replace the filters to maintain your vacuum's suction power.
To prevent damage from cleaning chemicals, rinse filters with cold water only. Allow all filters
to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn
into electricparts.
CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
IMPORTANT: DO NOT use soap when cleaning the filters.
IMPORTANT: Unplug the power cord before performing any maintenance.
Empty the dust cup each time you vacuum and periodically during cleaning,
when debris in the dust cup reaches the MAX fill line.
Post-Motor
HEPA Filter
Foam
Felt
Filter
Door
NOTE: Replace pre-motor filters every 2.5 years. Replace HEPA filter every 3 years.