Shark Navigator SWIVEL PLUS NV40 Series - Maintenance; Emptying the Dust Cup; Cleaning the Filters

13 14
1-800-798-7398 sharkclean.com
To keep your vacuum’s
suction power optimal,
follow these instructions.
Make sure unit is o and
cord is unplugged.
MAINTENANCE
EMPTYING THE DUST CUP
1 Lift the dust cup o
the pod by pulling up
on the release latches
on the sides of the
Dust Cup handle.
2 Hold dust cup over
a trash bin and press
the bottom Dust Cup
Release latch.
3 or Allergy Suerers:
Wrap a trash bag
around the Dust Cup
leaving space at the
bottom for the door to
swing open.
CLEANING THE FILTERS
1 Pre-Motor
(foam and felt):
With the dust cup
removed, take out the
foam and felt filters,
and rinse with water.
Tap loose dirt o
filters between washes
asneeded. Allow filters
to air-dry completely
before reinstalling.
2 Post-Motor (HEPA):
To access the HEPA
filter, reach under the
grill, pull the latch
forward, and pull the
grill away from the
vacuum. Remove
and rinse the HEPA
filter with water only.
Allow filter to air-dry
completely before
reinstalling.
STEP 1 STEP 2 STEP 3
IMPORTANT:
DO NOT use soap when
cleaning the filters.
RECOMMENDED
FILTER CLEANING
SCHEDULE:
Pre-Motor Filter Kit
(Foam & Felt)
XFF600
Clean every 3 months.
Post-Motor Filter
(HEPA)
XHF600
Clean once a year.
Post Motor
Filter
Pre-Motor
Felt Filter
(Felt Side Up)
Pre-Motor
Foam Filter
Filter
Frame
Filter Frame
(Underside)