sharkclean.comsharkclean.com
NOTE: All accessories are compatible with both the wand and the handle.NOTE: For deep carpet cleaning per ASTM F608 (embedded dirt in carpets), set to MAX suction and use setting II, Carpet.
WHOLE-HOME CLEANING
CLEANING MODES
To engage Brushroll, step on floor nozzle
and tilt handle back firmly.
Select surface setting:
O O
I Hard Floor
For bare floors and area rugs, the brushroll will
spin slowly.
II Carpet
For carpets, the brushroll will spin quickly to pick
up stuck on debris.
WHAT DOES THE BRUSHROLL INDICATOR LIGHT MEAN?
Solid Green: The brushroll is spinning and working as intended.
Solid Red: There is a jam in the brushroll area. Turn o and unplug the vacuum and remove
any blockages in the nozzle.
Flashing Red: The motorized floor nozzle is overheating. Turn o the vacuum, unplug it, and
remove any blockages. Let the vacuum cool down for at least 60 minutes before restarting.
See Troubleshooting section for more information.
Press the Wand Release button and pull up
on the wand to detach it from the pod. Attach a
cleaning accessory to the wand.
Press the Handle Release button and pull up
on the handle to detach it from the wand. Attach a
cleaning accessory to the handle.
UPRIGHT MODE
POWER/SURFACE SWITCH
INDICATOR LIGHT
ABOVE-FLOOR—WANDABOVE-FLOOR—HANDLE
WHOLE-HOME CLEANING
SETTINGS
BRUSHROLL INDICATOR LIGHT
The Suction Control Slider located on the handle
allows you to adjust the suction depending on
the floor type.
MIN: to reduce suction and increase
maneuverability on carpets.
MAX: to increase suction on bare floors.
SUCTION CONTROL
To Next Page
Loading...
