Shark Navigator ZU51 Series - Maintenance and Blockage Checks; Brushroll Cleaning; Hose, Wand, and Pod Blockages; Dust Cup Blockages

sharkclean.comsharkclean.com
CLEANING THE BRUSHROLL
MAINTENANCE
CHECKING FOR BLOCKAGES
Detach hose from vacuum pod, and check hose
and opening on back of pod for blockages.
Detach wand from pod and handle, and check both
ends for blockages.
Detach wand from pod, and check opening
for blockages.
Detach handle from wand and hose from vacuum
pod, and check openings for blockages.
Detach dust cup from vacuum pod. Empty dust
cup, remove debris from lint screen, and check for
blockages.
HOSE BLOCKAGES WAND BLOCKAGES
POD BLOCKAGES HANDLE/HOSE BLOCKAGES
DUST CUP BLOCKAGES
To access the brushroll, open
the locks on the bottom of the
nozzle. With a coin, turn the locks
counterclockwise to open, then lift
o the cover.
BRUSHROLL ACCESS
NOTE: If any hair is wrapped around the brushroll, extending cleaning time will allow the self-cleaning
brushroll to remove it for you. If some hair wrap remains after continued use, carefully remove it from the brushroll.
DEBRIS
WRAPPED
AROUND
BRUSHROLL
Clean o any
debris on the
bristles.
DEBRIS BEHIND
BRUSHROLL
Clear away any
dust, dirt, or
blockages in
Debris Intake. To
close the cover,
push down until it
clicks into place,
then close the
locks with a coin.
Self-Cleaning Brushroll
Shark's self-cleaning brushroll automatically removes hair wrap. If some hair remains wrapped
around the brushroll, continue cleaning to give it time to make its way to the dust cup. If you run
over a hard or sharp object or notice a noise change while vacuuming, check for blockages or
objects caught behind the brushroll.
To minimize the risk of power cord damage, DO NOT run the vacuum over the power cord. If this
occurs, immediately shut o power to the vacuum and remove the cord from the brushroll or nozzle.
1. DO NOT pull or carry vacuum cleaner by
the cord or use cord as a handle.
2. DO NOT unplug by pulling on the cord.
Grasp the plug, not the cord.
3. DO NOT close the door on the cord.
4. DO NOT pull the cord around sharp
corners.
5. DO NOT leave the cord near heated
surfaces.
CORD MAINTENANCE