Shark Navigator ZU51 Series - Dust Cup and Filter Maintenance; Emptying the Dust Cup; Cleaning Filters; Replacing Filters

sharkclean.comsharkclean.com
EMPTYING THE DUST CUP
To remove Dust Cup, slide up the release button
on the dust cup handle. Tilt dust cup forward,
then lift to remove.
To reinstall, place the bottom of dust cup
onto the pod and then tilt until it clicks into
place.
Press the release button to open bottom of
dust cup.
To remove collected debris from Lint Screen,
press the top release button and lift the
handle to open the dust cup. Gently brush
lint screen toclean.
RINSE HEPA FILTER
EVERY YEAR
Remove dust cup, tilt Filter Door and firmly
pull it o. Press tab at top of HEPA Filter and
pull out filter. To reinstall, insert HEPA filter
into unit and replace the filter door.
RINSE PRE-MOTOR FILTERS
EVERY MONTH
Remove Dust Cup, then lift out Filters.
Regularly rinse and replace the filters to maintain your vacuum's suction power.
To prevent damage from cleaning chemicals, rinse filters with cold water only. Allow all filters
to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into
electronicparts.
CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
IMPORTANT: DO NOT use soap when cleaning the filters.
IMPORTANT: Unplug the power cord before performing any maintenance.
Empty the dust cup each time you vacuum and periodically during cleaning,
when debris in the dust cup reaches the MAX fill line.
Post-Motor
HEPA Filter
Foam
Felt
Filter
Door
NOTE: To order replacement parts and filters, visit sharkaccessories.com.
Replacement
Pre-Motor Foam &
Felt Filter Kit
1239FT60
Replacement
HEPA Filter
1238FT60
Follow the previous instructions for removing filters. The Pre-Motor Filter should be replaced
every month. The HEPA Filter should be replaced every year.
REPLACING FILTERS