8
www.sharkninjamanuals.com
b
c
Upper Cord
Storage
Wrap
To reduce the risk of electric shock, unplug the unit before assembling, adding or removing attachments or
converting modes.
WARNING: The On/Off switch is on the top of the Lift-Away
™
canister. Always ensure the power is OFF
(“O” position) before plugging and unplugging.
TO ASSEMBLE:
1 Place the floor nozzle on a level surface.
2 Align the tube of the floor nozzle with the tube on
the Lift-Away
™
canister and lower until you hear the
two pieces click into place. (Fig. 3)
When attaching the motorised floor nozzle, ensure
that the latching mechanism is fully locked in place
to ensure electrical connection has been made.
3 Attach the end of the extension wand to the tube on
the back of the Lift-Away
™
canister until it clicks into
place. (Fig. 4)
4 Slide the accessory holder (a) positioned opposite
the upper cord wrap, over the extension wand. Align
the tab with the groove and push down. (Fig. 5)
5 Push the handle (b) onto the top of the extension
wand until you hear it click into place. (Fig. 5)
6 Insert the end of the stretch hose (c) into the
connector on the back of the Lift-Away
™
canister.
(Fig. 5)
7 Store the dusting brush (d) and the crevice tool (e)
on the mounts of the accessory holder (a). (Fig. 5)
Fig. 3 Fig. 4
Fig. 5
Mode 1: Upright Vac
a
d
e
To Next Page
Loading...
Need help?
General
