EMPTYING THE DUST CUP
1 Detach the removable Dust Cup from the Motorized Floor Nozzle by pressing the Dust Cup Release Foot Pedal located on the left side near the Nozzle�
2 Holding the Dust Cup by the handle, lift it up to remove it from the Motorized Floor Nozzle�
3 Hold the Dust Cup over a garbage bag or can, then press the Empty button on the side of the Dust Cup� The bottom lid will open, allowing the debris to fall out�
4 Clean the dust screen inside the Dust Cup as required�
MAINTENANCE
To keep your vacuum’s suction power optimal, follow these instructions.
IMPORTANT: Allow ALL filters to dry completely before replacing in the vacuum.
Make sure unit is off and cord is unplugged.
CLEANING THE FILTERS
Pre-Motor Filters
5 Access the Pre-Motor Filters by pressing the FILTER ACCESS latch on the
top of the Dust Cup� Remove and rinse the foam and felt filters every
month� Let air-dry COMPLETELY before replacing in the vacuum� Hand
wash only� Tap loose dirt off filters between washes as needed� Insert
the felt filter first, and then place the foam filter on top of it�
Post-Motor Filter
6 Access the Post-Motor Filter on the top of the Motorized Floor
Nozzle� Remove and rinse once a year� Let air-dry completely before
replacing� Hand wash only�
Post-Motor Filter
Pre-Motor Filters
Filter Access Latch
Foam
Felt
STEP 1 STEP 2 STEP 3
RECOMMENDED FILTER CLEANING SCHEDULE:
Pre-Motor Filter Kit (Foam & Felt): XFFH400 Every month
Post-Motor Filter: XEXFH400 Every year
7
www.sharkninjamanuals.com
To Next Page
Loading...
Need help?
General
