CLEANING THE POWERHEAD
TO ACCESS THE BRUSHROLL
1 Slide the Brushroll Cover Release Buttons out�
2 Pull up to open the hood of the Motorized
Floor Nozzle�
3 Lift the tab on the Brushroll up to remove it
from the Motorized Floor Nozzle�
4 Remove any string, carpet fibers, or hair that
is wrapped around the Brushroll� The groove
on the Brushroll allows a pair of scissors to
cut the debris without damaging the bristles�
5 The Brushroll can be removed and rinsed
under running water� Let the Brushroll air-dry
completely before replacing in the Motorized
Floor Nozzle�
6 To reassemble, hold the Brushroll by the tab
and align the other end with the gear� Then
with the tab facing up, place the Brushroll in
the Motorized Floor Nozzle�
7 Close the Brushroll cover� Listen for a click and
make sure the release buttons are fully closed�
IMPORTANT: DO NOT place the Brushroll in the
dishwasher to wash or the dryer to dry� DO NOT
submerge the Brushroll in water�
IMPORTANT: Using a wet Brushroll in the
Motorized Floor Nozzle will void your warranty.
STEP 1 STEP 2 STEP 3
STEP 4 STEP 5 STEP 6 STEP 7
IMPORTANT: Remove Brushroll from unit before rinsing.
IMPORTANT: Make sure Brushrolls are completely dry before replacing in the vacuum.
Make sure unit is off and cord is unplugged.
8
1-800-798-7398
English
To Next Page
Loading...
Need help?
General
