WARNING: To reduce
the risk of shock and
unintended operation,
turn power off and
unplug unit before
servicing�
IMPORTANT: Remove
brushroll before rinsing.
IMPORTANT: DO NOT
place brushroll in the
dishwasher to wash or
the dryer to dry. DO NOT
submerge brushroll in
water.
IMPORTANT: Using
a wet brushroll in the
floor nozzle will void your
warranty.
DID YOU KNOW?
The brushroll endcap is
removable to help clear hair/
debris. Ensure the endcap
is pressed firmly onto the
brushroll to reassemble.
MAINTENANCE
1 Slide the brusholl garage
release buttons out.
2 Pull up to open the
brusholl garage.
5 The brushroll can be
rinsed under running
water. Let the brushroll
air-dry completely before
replacing in the vacuum.
6 To reassemble, hold the
brushroll by the endcap
and align the other end
with the gear. With the
endcap facing up, place
the brushroll in the floor
nozzle.
3 Lift the endcap on the
brushroll up to remove it
from the floor nozzle.
4 Remove any hair, fibers,
or debris wrapped around
the brushroll. The groove
on the brushroll allows
scissors to cut the debris
without damaging the
bristles.
7 Close the brushroll garage.
Listen for a click and make
sure the release buttons
are fully closed.
NOTE: The brushroll will only spin
if the brushroll cover is fully closed
and locked.
ACCESSING & CLEANING
THE BRUSHROLL
STEP 1
STEP 4STEP 2
STEP 5STEP 3 STEP 6 STEP 7
To Next Page
Loading...
Need help?
General
