IMPORTANT: Always
inspect wires for damage
before assembly.
ASSEMBLING
YOUR VACUUM
1 Insert upper part of the wand into lower portion while
pressing the Height Adjust button until you hear a click.
Make sure not to pinch the wires.
STEP 1
DID YOU KNOW?
The floor nozzle has LED
headlights that illuminate the
floor surface being cleaned.
The lights turn on automatically
in either speed setting.
2 Open the holster collar by pressing “Press
to detach holster”
Place the collar so it rests on top of the
lower cord hook
Close the collar. You will hear a click.
3 Open the holster by squeezing the two
ends and insert the spare brushroll. Close
before using the vacuum.
STEP 2 STEP 3
To Next Page
Loading...
