sharkclean.comsharkclean.com
(Click)
ASSEMBLY
1. Insert Wand into Motorized Floor Nozzle connector.
2. Insert Handheld Vacuum into wand.
Ensure all connections click securely into place.
(Click)
SETTINGS
CLEANING MODES
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please use setting II.
NOTE: All accessories attach to either the wand or the handheld vacuum.
1 2
Slide switch to the bottom
to turn o power. To begin
vacuuming, slide switch to
the appropriate setting.
The brushroll and the Soft
Roller both spin together
slowly to clean bare floors
and area rugs. The Soft
Roller traps fine dust and
large particles, while the
brushroll directs that debris
to the suction channel
Both brushrolls spin faster,
working together to
pick up debris below the
surface ofyour carpets.
OFF SETTING I SETTING II
To clean floors, place foot on floor nozzle and tilt
handheld vacuum back.
UPRIGHT
Stand the vacuum upright. Step on the foot pedal
on the bottom left side of the floor nozzle and pull
the wand up to disconnect it. Great for cleaning
baseboards, ceiling fans, window sills, etc.
ABOVE-FLOOR WITH WAND
Press the Wand Release button and lift the
handheld vacuum o the wand. Great for cleaning
stairs and furniture.
ABOVE-FLOOR HANDHELD
Wand
Release
WHAT DOES THE BRUSHROLL INDICATOR LIGHT MEAN?
Solid Green
The brushroll is on and working as it should.
Solid Red
There is a jam in the brushroll area. Turn your vacuum o and remove the blockage.
No Light: The vacuum is o.
Flashing Red: The vacuum has overheated. See Troubleshooting section.
To Next Page
Loading...
Need help?
General
