sharkclean.comsharkclean.com
MAINTENANCE
MAINTENANCE
CHECKING FOR BLOCKAGES
CHECK HANDHELD
CHECK FLOOR NOZZLE
CHECK WAND
Remove the wand from the handheld vacuum and
check all dust cup intake openings.
Press down on the two buttons on the floor nozzle
to pop up the brushroll garage lid.
Press down on the two buttons on the floor nozzle to
pop up the brushroll garage lid. Remove the cover,
then tilt back the neck of the floor nozzle and check
the opening for blockages. Replace cover, pressing
down firmly on all sides until it clicks into place.
To reinstall the brushroll, return it to the brushroll
garage.
Press down on the brushroll garage lid until it clicks
into place.
Detach the wand and check it for blockages. Remove the brushroll by pulling the tab on the
left side. To remove any string, hair, or debris that
may be wrapped around the brushroll, use the
onboard Hair Removal Tool. The tool is located in a
compartment on the nozzle, above the brushroll.
MAINTAINING THE BRUSHROLL
(Click)(Click)
To Next Page
Loading...
Need help?
General
