sharkclean.comsharkclean.com
MAINTENANCE
MAINTENANCE
EMPTYING THE DUST CUP
Press the WAND RELEASE button and lift the
handheld vacuum o the wand.
With the dust cup attached to the handheld vacuum,
press the Empty button on the front of the dust cup.
To remove the dust cup from the handheld vacuum,
squeeze the two Dust Cup Release buttons at the
same time and pull out the dust cup. Press the Empty
button on the front of the dust cup.
Perform regular maintenance on your filters to keep your vacuum's suction power optimal.
IMPORTANT:
To prevent damage, rinse filters with water
ONLY
.
DO NOT
use soap. Allow filters to air-dry for
at least 24 hours before reinstalling them to prevent liquid from being drawn into electricparts.
The dust cup needs to be emptied each time you vacuum and periodically during cleaning, when debris in
the dust cup reaches the MAX fill line.
CLEANING FILTERS
Clean Filter
IMPORTANT: Unplug the vacuum before performing any maintenance. IMPORTANT: Unplug the vacuum before performing any maintenance.
PRE-MOTOR FILTERS POST-MOTOR FILTER
Replacement Pre-Motor Filter Kit
XPMFK320
Replacement Post-Motor Filter
XPSTFH380
REPLACEMENT FILTERS
OR
Empty
Dust Cup
Release
Wash the pre-motor filters once a month. Wash the post-motor filter once a year.
NOTE: The pre-motor filters should be
replaced every 2.5 years. The post-motor filter
should be replaced every 3 years.
Wand
Release
To Next Page
Loading...
Need help?
General
