16sharkclean.com
ENGLISH
15 sharkclean.com
IMPORTANT: Clean the dust screen
inside the dust cup as required.
NOTE: Empty dust cup when debris
reaches the MAX fill line.
MAINTAINING YOUR VACUUM
EMPTYING THE DUST CUP
1 Press the Wand Release button on
the top of the wand to disconnect
it from the handheld vacuum.
OR
Remove the dust cup from the
handheld vacuum by squeezing the
two Dust Cup Release buttons on
both sides of the base at the same
time and pulling it out.
2 Hold dust cup over a trash bin and
press the Empty button on the front
of the dust cup. The bottom lid will
open, allowing the debris to fall out.
3 Once dust cup is empty, close the
bottom lid and insert dust cup back
into handheld vacuum until you it
clicks into place.
RECOMMENDED FILTER CLEANING
SCHEDULE:
Pre-Motor Filter Kit
(Foam & Felt)
XPMFK320
Clean once a month.
Post-Motor Filter
Clean once a year.
1084FTV320
CLEANING THE FILTERS
1 Pre-Motor (foam and felt):
Lift the latch on the top of the
handheld vacuum to open the filter
cover. Take out filters and tap loose
dirt o them. If more cleaning is
needed, rinse filters with water only
and let them air-dry completely.
To reinstall them, insert the felt
filter first, place the foam filter on
top of it, and close the filter cover.
2 Post-Motor:
Lift o the post-motor filter cover
below the handle of the handheld
vacuum. Remove the filter, rinse it
with water only, and let it air-dry
completely. Replace the filter, then
close the cover, pressing it until it
clicks into place.
Foam
Felt
To Next Page
Loading...
Need help?
General
