Name: Shark Rotator NV340ANZ
Brand: Shark
Rating: 5 (1 reviews)

To Next Page

To Previous Page

AUST: 1800 890 840

Euro-Pro and Shark are registered trademarks of Euro-Pro Operating LLC.

Rotator, Dust-Away and Lift-Away are trademarks of Euro-Pro Operating LLC.

Vacuum is not picking up dirt. No suction or light suction

• Check ﬁlters to see if they need cleaning. Follow instructions for rinsing and drying the ﬁlters before re-inserting back into the vacuum.

•Dustcupmaybefull;emptydustcup.

•Checkhose,hoseconnections,nozzlesandaccessoriesforblockages;clearblockagesifrequired.

•Close the suction release on the handle to increase suction power.

Vacuum lifts area rugs

•Suctionispowerful.Takecarewhenvacuumingarearugsorrugswithdelicatelysewnedges.Openthesuctionreleaseonthehandletodecreasesuctionpower.

•TurnofftheunittodisengagethebrushrollandrestartwiththePOWERbuttonforsuctiononlycleaning.

Brush roll does not spin

•Pullthehandletowardyouandreleasetheoornozzletodisengagetheauto-offfeature.

•TurntheunitonbypressingtheBRUSHROLLbutton.

•  I mmediately turn off and unplug vacuum, disconnect the nozzle and remove blockage before reconnecting and turning vacuum back on.

Vacuum turns off on its own

• This vacuum cleaner is equipped with a motor protective thermostat. If for some reason your vacuum overheats, the thermostat will automatically turn the unit off.

Should this occur, perform the following steps to restart the motor thermostat:

1. Turn the unit off.

2. Unplug the vacuum.

3. Empty the dust cup and clean ﬁlters.

4. Check for blockages in hose, accessories and inlet openings.

5. Allow the unit to cool for a minimum of 45 minutes.

6. Plug in the vacuum.

7. Restart the unit using either the POWER or POWER + BRUSHROLL buttons.

Note: If vacuum still does not start, contact Customer care at: AUST: 1800 890 840 or NZ: 0800 002 999.

TROUBLE-

SHOOTING

GUIDE