UPRIGHT
CLEANING
ABOVE FLOOR
CLEANING
1 Press POWER to clean bare floor surfaces, area rugs or areas above-floor. The brushroll will not spin in this mode.
2 Press POWER and BRUSHROLL to clean carpets. The brushroll indicator lights will illuminate GREEN. If there is a jam, the indicator light on floor nozzle will illuminate RED. Refer to
MAINTENANCE (page 9) for instructions on removing blockages.
3 Place your left foot gently on the floor nozzle and tilt the handle back to start cleaning. Note: The brushroll will only spin once the vacuum is reclined back.
4 To clean with the hose, press the WAND or HANDLE release button (depending on the amount of reach required) then lift the handle up.
5 Attach desired cleaning accessory. Note, the handle will slide into the accessory and the wand will slide over the accessory.
POWER
Bare floor or wand cleaning
POWER +
BRUSHROLL
Carpet cleaning
3
OR
OR
4
5
4
1
1
2
WARNING: When vacuuming fine dust (sawdust, sand, flour, talcum powder, etc.) electrostatic charges build up naturally. Under certain conditions
these electrostatic charges will be released. To avoid the unpleasant effects of static discharges, a metal strip has been incorporated into the right
side of the handle. PLEASE MAKE SURE THAT YOU KEEP YOUR HAND IN CONSTANT CONTACT WITH THIS METAL STRIP DURING VACUUMING.
OR
CORRECT
INCORRECT
To Next Page
Loading...
Need help?
General
