sharkclean.com sharkclean.com
Suction
Control
MAX MIN
NOTE: For deep carpet cleaning per ASTM F608 (embedded dirt in carpets), set to MAX suction and press Brushroll button.
Press the POWER button to clean hard-floor surfaces,
area rugs, or above-floor areas. The brushroll will not
spin in this mode.
To clean carpets, press the power button and the
Brushroll button. The brushroll will spin only when
the handle is tilted back and the Brushroll Indicator
Light is green.
The Suction Control slider located on the top
of the handle allows you to adjust the suction
depending on the floor type.
MIN: to reduce suction and increase
maneuverability on carpets.
MAX: to increase suction on bare floors.
WHAT DOES THE BRUSHROLL
INDICATOR LIGHT MEAN?
Solid Green: The brushroll is spinning
and working as it should.
Solid Red: There is a jam in the brushroll
area. Turn your vacuum o, unplug from
the wall and remove any blockages in
the nozzle.
Flashing Red: The motorized floor
nozzle is overheating. Turn o the
vacuum, unplug it, and remove any
blockages. Let the vacuum cool down
for at least 60 minutes before restarting.
See Troubleshooting section for more
information.
POWER BUTTON BRUSHROLL BUTTON
WHOLE-HOME CLEANING
POWER, BRUSHROLL, AND SUCTION CONTROL
BRUSHROLL INDICATOR LIGHTSUCTION CONTROL
NOTE: All accessories are compatible with both the wand and the handle.
WHOLE-HOME CLEANING
CLEANING MODES
To engage brushroll, step on floor nozzle
and tilt handle back.
UPRIGHT
Press the Lift-Away button to detach
the pod from the floor nozzle.
LIFT-AWAY®
With pod removed, press the Wand Release
button to detach the wand from the pod.
LIFT-AWAY—WAND
Cord
Hook
Press the Handle Release button
to detach the handle from the wand.
ABOVE-FLOOR—HANDLE
To Next Page
Loading...
Need help?
General
