sharkclean.com sharkclean.com
EMPTYING THE DUST CUP
To remove Dust Cup from pod, pull up on release
latches. Tilt dust cup, then lift to remove.
To reinstall, place bottom of dust cup into
pod and then tilt it until it clicks into place.
Hold dust cup over a trash bin and press
LOWER RELEASE button to open bottom lid.
Press top dust-cup release latch to access
dust screen and remove built-up debris
asrequired.
CLEAN POST-MOTOR FILTER EVERY YEAR
Press button at bottom of Filter Door. Tilt
Filter Door and lift out. Remove Post-Motor
Filter (HEPA). To reinstall, insert filter into unit
and replace the filter door.
CLEAN PRE-MOTOR FILTERS
EVERY 3 MONTHS
Remove Dust Cup, then lift out Filters.
Regularly rinse and replace the filters to keep your vacuum's suction power optimal.
TO PREVENT DAMAGE FROM CLEANING CHEMICALS, RINSE FILTERS WITH COLD WATER
ONLY. ALLOW ALL FILTERS TO AIR-DRY FOR AT LEAST 24 HOURS BEFORE REINSTALLING
THEM TO PREVENT LIQUID FROM BEING DRAWN INTO ELECTRICPARTS.
CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
IMPORTANT: DO NOT use soap when cleaning the filters.
IMPORTANT: Unplug the power cord before performing any maintenance.
Empty the dust cup each time you vacuum and periodically during cleaning,
when debris in the dust cup reaches the MAX fill line.
FILTER
DOOR
FELT FILTER
FOAM FILTER
FILTER FRAME
POST-
MOTOR
FILTER
(HEPA)
Using a coin, turn the locks to the
unlock position and pull up to expose
the airway. Remove any blockages.
With scissors, carefully cut away any
string, hair, or debris that may be
wrapped around the brushroll.
CLEANING THE BRUSHROLL
MAINTENANCE
NOTE: The pre-motor filters should be replaced every 2.5 years. The post-motor filter should be replaced every 3 years.
To Next Page
Loading...
Need help?
General
