Shark Rotator NV650 Series User Manual

sharkclean.com sharkclean.com
CLEANING AND REPLACING THE FILTERS
Regularly clean and replace the filters to keep your vacuum's suction power optimal.
To clean filters, rinse with cold water ONLY to prevent damage from cleaning chemicals. Allow
all filters to air-dry for at least 24 hours before reinstalling them to prevent liquid from being
drawn into electricparts.
Pre-Motor (foam and felt):
With the dust cup removed, take out and
rinse the foam and felt filters with water.
Tap loose dirt o filters between washes
asneeded.
CLEAN PRE-MOTOR FILTERS EVERY
3 MONTHS.
Post-Motor (HEPA):
To access the HEPA Filter, pull the latch
under the filter cover and take o the cover.
Take out the HEPA filter and rinse it.
CLEAN HEPA FILTER EVERY YEAR.
CLEANING FILTERS
IMPORTANT: DO NOT use soap when cleaning the filters.
NOTE: To order replacement parts and filters, visit sharkaccessories.com.
Replacement
Pre-Motor Foam &
Felt Filter Kit
XFF650
Replacement
HEPA Filter
XHF650
Follow the previous instructions for removing filters. The pre-motor filters should be replaced every
2.5 years. The post-motor HEPA filter should be replaced every 3 years.
REPLACING FILTERS
HEPA
Felt Filter
Foam Filter
Filter Frame
Filter Access
CHECKING FOR BLOCKAGES & MAINTAINING BRUSHROLL
Use the edge of a coin to open the
3 locks on the bottom of the floornozzle.
Lift up the lid on the bottom of the
nozzle to access the brushroll. Use
a flashlight to check for blockages.
With scissors, carefully cut along the
groove in the brushroll to remove any
debris, hair, or fibers.
To reinstall the lid, line it up along the
front of the nozzle and press it closed.
Use the coin to close the 3 locks.

Shark Rotator NV650 Series Specifications

General

Type	Upright
Technology	Lift-Away
Filtration	HEPA
Bagless	Yes
Cord Length	30 feet
Weight	15.5 lbs
Amperage	10 Amps
Dust Cup Capacity	1.3 quarts
Model	NV650
Power Source	Corded Electric
Special Features	LED headlights