10. Mechanical Specification
Weight TBD
Height TBD
Depth TBD
Physical
Dimension
Net Weight TBD
Gross Weight TBD
Units per Pallet TBD
Pallet Dimension TBD
40’ Container
Loading
TBD
Packing
Specification
Carton Label TBD
Display Head ABS UL94HB
Neck / Base ABS UL94HB
Internal Plastic ABS UL94HB
Cabinet Color
Drift
The color drift due to UV-Light shall be less than 3.0 “Delta E”
in the 1976 CIE L*a*b colorspace. Testing shall be performed
according to the requirements of ASTM Test Method D4459-
93.
Cabinet
Material
Cabinet Texture
Mold-Tech # 11010 used on all external textured
surfaces.
Bezel The max. gap to the panel glass shall be less than 1.0 mm
Gap
Specification
Bezel / Speaker
Cover
The max gap between the bottom of the front bezel and
the top of the speaker cover shall be less than 1.2 mm. The
gap deviation must be less than 0.3mm
Ergonomics Tilt Down 0º up to 1º
Screen Printed
Parts
Artwork : TBD
Front Panel
Buttons Tactile
Button Alignment
The gap clearance between the buttons and the bezel
surface shall be uniform
Surface Quality
Surface color, gloss, texture, blemishes, and all other
irregularities in the plastic shall comply with TVIs approval
sheet.
Others
Fade and Color
change
All external surfaces shall be sufficiently rugged to withstand
normal operator usage without extreme visible deterioration
in color.
A surface
No defects such as knit lines, parting line, defects in texture,
gate marks, flash, sinks etc. should be visible from a distance
of 18 inches.
B surface
Defects such as knit lines, parting line, defects in texture,
gate marks, flash, sinks etc. should be visible from a distance
of 30 inches.
Cosmetic
Criteria for
Molded Plastic
C surface
Unacceptable defects are limited to voids or breaks in the
plastic or gross mold distortions.
Vibration
Frequency : 1 – 200 Hz
Vibration Test
Acceleration : 1.14 G RMS
86 190TW8 TV
To Next Page
Loading...
