Sharp 903SH - Page 106

Settings 105
Withheld Call
When the “Withheld Call” is set, incoming calls without a CLI (Calling
Line Identification) are rejected.
“Settings”
→ “Call Settings” → “Restrict Calls” →
“Withheld Call”
1. Select “On” or “Off”.
Changing the Network Password
“Settings”
→ “Call Settings” → “Restrict Calls” → “Change
N/W Password”
1. Enter the old network password.
2. Enter a new network password.
3. Enter the new network password again.
If you enter the incorrect password, you are asked to enter the
password again.
4. Press .
Fixed Dialling Number
When the Fixed Dialling Number is enabled, you can only call
pre-registered numbers.
To Enable Fixed Dialling Number
“Settings”
→ “Call Settings” → “Restrict Calls” → “Fixed
Dialling Number” → “Switch On/Off”
1. Select “On” to enable this function.
To Add a New Name
“Settings”
→ “Call Settings” → “Restrict Calls” → “Fixed
Dialling Number”
→ “Edit Dial List”
1. Highlight the blank entry, press [Options], then select “Add
New Dial”.
2. Enter your PIN2 code.
3. Add a name and a phone number.
For details on adding a name and a phone number, see “Add New
Contact” on page 35.
4. Press [Save].
Minute Minder
Minute Minder function informs you of your talk time by sounding a
tone after every minute.
“Settings”
→ “Call Settings” → “Minute Minder”
1. Select “On” or “Off”.
Displaying Call Time Counter
“Settings”
→ “Call Settings” → “Call Time Counter”
1. Select “On” or “Off”.
Displaying Call Costs
“Settings”
→ “Call Settings” → “Display Call Cost”
1. Select “On” or “Off”.
(M 12-6-5)
(M 12-6-6)
(M 12-6-7)