ENGLISH
EN-6
1
Press the MODE button to select the
operation mode.
2
Press the ON/OFF button to start oper-
ation.
•
The green OPERATION lamp
( )
will light up.
• The lighting bar will light up to different colors.
For more information, refer to page EN-13.
(For XP10/13UXD, XP10/15UF models only)
TO TURN OFF
Press the ON/OFF button again.
•
The green OPERATION lamp
( )
will turn off.
• The lighting bar will turn off.
(For XP10/13UXD, XP10/15UF models only)
3
Press the THERMOSTAT button to set the
desired temperature, you can set temper-
ature in 0.5
°
C increments.
(AUTO/DRY mode)
The temperature can be
changed up to ±2.0°C from
the automatic setting.
(COOL mode)
The temperature setting
range: 14.0-30.0°C.
4
Press the FAN button to set the desired
fan speed.
In FAN mode, fan speed cannot be set to AUTO.
BASIC OPERATION
NOTE:
AUTO MODE
In the AUTO mode, the temperature setting and
mode are automatically selected according to the
room temperature when the unit is turned on.
DRY MODE
The fan speed is preset to AUTO and cannot be changed.
WHEN POWER FAILURE OCCURS
This air conditioner has a memory function to store
setting when a power failure occurs.
After power recovery, the unit will automatically re-
start in the same settings which were active before
the power failure, except for TIMER, SUPER JET,
BEST SLEEP, BABY MODE, ECO MODE,
SELF
CLEAN settings.
1
4
3
2
SENSOR
AUTO BREEZE QUIET SOFT LOW HIGH
BREEZE QUIET SOFT LOW HIGH
FAN AUTO COOL DRY
To Next Page
Loading...
