SET UP THE SOFTWARE
48
5
Double-click the "setup" icon ( ).
6
The "SOFTWARE LICENCE" window will appear. Make sure
that you understand the contents of the software licence, and
then click the "Yes" button.
7
Read the "Readme First" in the "Welcome" window and then
click the "Next" button.
Set the IP Address
This setting is only required once when using the machine on a network.
8
Click the "Set the IP
Address" button.
If the language selection screen appears after you double click the
"setup" icon, select the language that you wish to use and click the
"Next" button. (Normally the correct language is selected
automatically.)
To set the IP address of the machine, follow the steps below. If the
machine is already connected to the network and its IP address has
been set, go to "LPR (TCP/IP) direct printing" (p.50).
Note
Note
To Next Page
Loading...
