USER SETTINGS
66
9
AE/TEXT
RESOLUTION
1: 300dpi
2: 600dpi
• The copy resolution in auto
and text mode is normally 300
dpi. If high-quality copies are
preferred, use this setting to
change the resolution to 600
dpi.
10
2-SIDED COPY
MODE
1: HI-SPEED
2: NORMAL
• If the memory fills up when
two-sided copying is
performed, "NORMAL" can be
selected to make copying
possible. However,
"NORMAL" results in a slower
copying speed. Normally "HI-
SPEED" is selected to enable
fast two-sided copying.
11 MARGIN WIDTH
1: 5 mm
2: 10 mm
3: 15 mm
4: 20 mm
• Use this setting to set the
margin width.
12
MEM. FOR
PRINTER
1: 30%
2: 40%
3: 50%
4: 60%
5: 70%
• Use this to change the
proportion of machine
memory used for printer
mode.
13
AUTO KEY
REPEAT
1: ON
2: OFF
• Use this setting to select
whether or not holding down a
key causes repeated input of
the key. For keys that
normally cause a set value to
increase when held down (for
example, holding down the
[ ] key ( ) or [ ] key
( )), this program can be
used to have the set value not
change when the key is held
down.
14 KEY PRESS TIME
1: NORMAL
2: 0.5 SEC.
3: 1.0 SEC.
4: 1.5 SEC.
5: 2.0 SEC.
• Use this setting to select how
long a key must be pressed
for the input to be accepted.
By selecting a longer time,
you can prevent settings from
being changed by the
accidental pressing of a key.
15
KEY TOUCH
SOUND
1: LOW
2: HIGH
3: OFF
• This sets the volume of beep
signals. (p.70)
Program
number
Program name
Setting codes
(factory default
setting appears
in bold)
Explanation
To Next Page
Loading...
