Preparation
Before using the LCD
TV
set for the first time, install the two "AAA" size batteries supplied.
in
the remote control. When the
batteries become depleted and the remote control fails to operate, replace the batteries with new "AAA" size batteries.
1 Open the battery cover.
• Slide the cover while
pressing the (
T )
part.
2 Insert two "AAA" size batteries.
• Place batteries with their
terminals corresponding
to the
(+)
and
(-)
indications
in
the battery
compartment.
3 Close the battery cover.
• Engaging the lower
claw with the remote
control, close the cover.
Precautions regarding batteries
• Improper use
of
batteries can result
in
a leakage
of
chemicals and/or explosion. Be sure to follow the instructions below.
Place batteries with their terminals corresponding to the
(+)
and
(-)
indications.
Different types
of
batteries have different characteristics. Do not mix batteries of different types.
Do
not mix old and new batteries. Mixing old and new batteries can shorten the life
of
new batteries and/or cause old
batteries to leak chemicals.
Remove batteries as soon as they are depleted. Chemicals that leak from batteries can cause a rash. If chemical
leakage is found, wipe it off with a cloth.
The batteries supplied with the LCD
TV
set may have a shorter operating· time due to storage conditions.
If the remote control is not to be used for a long period
of
time, remove the batteries from the remote control.
• Use the remote control by pointing it towards the remote sensor
window
of
the main unit. Objects between
the
remote control and
sensor window may prevent proper operation.
Cautions regarding use of the remote control
• Do not apply shock to the remote control.
In
addition, do not
expose the remote control to liquids, and do not place it
in
an
area
with high humidity.
• Do not install or place the remote control
in
direct sunlight. The
heat may cause deformation
of
the unit.
• The remote control may not work properly if the remote sensor
window is
in
direct sunlight or strong lighting.
In
such a case,
change the angle of the lighting
or
main unit, or operate the
remote control closer to the remote sensor window.
Remote
sensor
@7
To Next Page
Loading...
