Direct Button Operation
You can change channels by pressing
CH_/_or 0-9, or • (DOT}.
Examples:
To select a 1 or 2-digit channel number
(e. g., Channel 5):
Press 5 _ ENT.
To select a 3-digit channel number
(e. g., Channel 115):
Press 1 _ 1 _ 5_ ENT.
To select a 4-digit channel number
(e. g., Channel 22.1):
Press 2_ 2_ • (DOT) _ 1
ENT.
• An image from the selected source
automatically displays.
• Each time INPUT is pressed, the
input source toggles.
• If you press A/_ to select the
input source, press ENTER to
confirm your selection.
• See page 19-22 for external equipment
connection.
Mutes the current sound output.
Press MUTE,
• Mute can be canceled by using the
method below.
Mute wilt be canceled if you press
VOL+/- or MUTE.
• When selecting a 1-digit channel
number, it is not necessary to press 0
before the number.
You can change the volume by pressing
VOL+ / on the TV or on the remote
control unit.
• To increase the volume, press
VOL+
• To decrease the volume, press
VOL .
To view external source images, select the
input source using INPUT on the remote
control unit or INPUT on the TV,
1. Press INPUT.
• A list of selectable sources
appears.
2. Press INPUT again to select the input
source.
Allows you to set a time when the TV
automatically switches to standby.
Press SLEEP.
• The remaining time displays when
the sleep timer has been set.
• Each time you press SLEEP, the
remaining time switches as shown
below.
Off, 10, 20, 30, 40, 50, 60, 90, 120
• When set, the time automatically
starts counting down.
• If you want to adjust the sleep
timer, you can press SLEEP twice
then change the time setting.
• Select "Off" by pressing SLEEP to
cancet the sleep timer.
• The TV wilt enter standby mode (power
indicator lights red) when the remaining
time reaches zero.
(D- 25
To Next Page
Loading...
