Sharp AQUOS LC-32LE280X - TV Rear Connections and Power; TV Rear Ports Overview; Power On;Off; Automatic TV Installation

Part Names (Continued)
Toggletelevision
ATTENTION
•
In some country settings, this unit may not display
“DTV”, “ATV” or “DTV + ATV” selection function.
•
The device may display the service or region selection
screen depending on the country setting or cable
provider selection. Follow the on-screen prompts to make
your selection.
TV (Rear)
Power on/off
LC-32LE280X
• To turn on the power
first
2
3
4
5
6
7
8
9
USB connector*
INPUT connector 1 (INPUT 1) (HDMI/ARC)
INPUT connector 2 (INPUT 2) (HDMI/MHL)
ANT connector (Antenna input)
Connector INPUT 3 (IN 3)
SERVICE Connector ONLY**
/AUDIO Output Connector (L/R)
ButtonPOWER(POWER) (On/Off)
Keyboard control
PressPOWER(SOURCE) on the TV or remote control. (After a
few seconds, the image appears along with the sound.)
• To turn off the power
USB
Turn off the TV by pressingPOWER(SOURCE) on the TV or
remote control.
first
Digital Setup
DC5V 1.5A
You can reconfigure the DTV service settings
automatically or manually.
AROLD
2
ATTENTION
•
If you do not use this TV for a long time, be sure to remove
the AC cord from the AC outlet.
•
The device consumes less power when in standby mode.
first
PressMENU(DRIVERS) and the DRIVERS
screen is displayed.
MHL
DC5V 0.9A
3
FUNCTION
WHILE OPENING
MENU
FUNCTION
BASIC
SMALL FILTER KEY
Automatic installation
2
3
PressCDto select “Initial installation”.
4
Pressa/bto select “Digital Setup”, then press
ENTER(ENTER). If you have set a password,
enter it here.
r
SMALL CHANNEL INCREASE
r
*
*
*
When turning on the TV for the first time after purchase,
the initial automatic setting appears. Follow the drivers
and make the necessary settings in turn.
5
S
REDUCTION SMALL CHANNEL
S
•
See “Child Lock” to set the password.
+
INCREASE VOICE
+
INPUT 3
8
first
PressPOWER(POWER) on the remote control.
4
Pressa/bto select the desired driver item, and
then pressENTER(ENTER).
SERVICE ONLY
6
7
–
VOICE REDUCTION
–
*
•
The initial automatic setting appears.
PressENTER(ENTER)to start the installation.
9
b (BELOW 1 SEC)
INPUT SELECT/IN
HAuto detect
2
Pressa/bto select the desired language, then
pressENTER(ENTER).
Pressa/bto select the country channel in
“Local”, then pressENTER(ENTER). PressCDto
select “Home” or “Display”, then pressENTER
(ENTER).
Use this menu to add new services
automatically after “Automatic Setup” has been
completed.
b (FROM 1 SECOND
ABOVE)
BACK/EXIT OUT
MENU
MENU
* Repeat keys
•
Pressa/bto select “DTV” or “DTV+ATV”.
LC-40LE280X
first
2
3
4
5
6
7
8
9
/AUDIO Output connector (L/
R) SERVICE ONLY connector**
INPUT 3 connector (IN 3) ANT
connector (Antenna input)
INPUT connector 2 (INPUT 2) (HDMI/MHL)
INPUT connector 1 (INPUT 1) (HDMI/ARC) USB
connector*
KnotPOWER(POWER) (On/Off)
Keyboard control
HManual search
Home:
Add new services to a specific band channel.
• “Standard” will be the default setting value for “AV
Mode”.
•
PressCDto tune in then pressENTER(ENTER).
first
2
Display:
• “Vivid (Fixed)” will be the default setting value for “AV
Mode”. If “AV mode” changes, the TV will
automatically return to “Dynamic (Fixed)” when
there are no other changes to the TV settings for 30
minutes.
•
To switch from Gallery mode to Home mode, refer
to page 16 to reset the device.
HSignal information
SERVICE ONLY
Use this driver to check the signal information according to
the available channel.
INPUT 3
3
FUNCTION
WHILE OPENING
MENU
FUNCTION
BASIC
SMALL FILTER KEY
3
Pressa/bto select “DTV”, “ATV” or “DTV + ATV” in
“Type Search”, then pressENTER(ENTER).
4
r
SMALL CHANNEL INCREASE
r
*
*
*
•
Automatic installation will be performed.
•
You don't need to do anything during auto
tuning.
•
If you select “Other” country some DTV channels
may not be tuned correctly.
MHL
DC5V 0.9A
5
S
REDUCTION SMALL CHANNEL
S
9
+
INCREASE VOICE
+
ARC
6
–
VOICE REDUCTION
–
*
PressCDto select “Start” or “Cancel”, and then
pressENTER(IN) to search for available
channels.
USB
8
7
b (BELOW 1 SEC)
INPUT SELECT/IN
DC5V 1.5A
b (FROM 1 SECOND
ABOVE)
BACK/EXIT OUT
MENU
MENU
* Repeat keys
* Use USB port for USB music player. (See page 27.)
* * Do not use to connect this input because it is only for KTV.
•
The illustrations and images displayed on the screen in this operating manual are for explanation purposes only and may differ
slightly from actual operation.
•
Some features may differ depending on the selected country.
11 twelfth
F271WJ
USB
DC5V 1.5A
ARC
INPUT 2
MHL
INPUT 3
SERVICE ONLY
DC5V 0.9A
INPUT 2
MHL
ARC
DC5V 0.9A
SERVICE ONLY
INPUT 3
USB
DC5V 1.5A
F311WJ