16
Searching for satellite broadcasts
(835 series only)
Press c/d to select “Yes”, and then press ;.
Yes
No
• If you do not perform “Satellite search” setting,
select “No”, and then press ;.
• The current DVB-S/S2 setting screen is displayed.
Next
other
Satellite
LNB Frequency
Low High
Satellite System
Max. 4 satellites on DiSEqC multiswitch
Change setting
• You must first complete “Change setting” before
moving to the “Next” setting.
1 When you change the antenna
connection setting:
Press c/d to select “Change setting”, and then
press ;.
• The antenna connection setting screen is displayed.
Single satellite
2 satellites on 22kHz switchbox
2 satellites on toneburst switchbox
Max. 4 satellites on DiSEqC multiswitch
Communal satellite system
NOTE
• You can select the antenna connection method from the
five types. Consult your dealers before using a method
other than “Single satellite”.
E
“Single satellite” setting
1
Press a/b to select “Single satellite”, and then
press ;.
2 Press a/b to select “SAT1 [None]” to display
the satellite broadcasts that the TV can receive,
and then press ;.
SAT1 [None]
Next
3 Press a/b/c/d to select your favorite
satellite, and then press ;.
• You cannot select “Next” unless you set the satellite
broadcast in step 3.
Euro Bird 1
Atlantic Bird 1
4 Press a/b to select “Next”, and then press
;.
SAT1 [ASTRA 1]
Next
5 Press c/d to select “Yes (0/22kHz)” or “No” to
set the LNB frequency, and then press ;.
Yes (0/22kHz)
No
6 Press a/b to select the item and press c/d
to adjust 9,000 MHz to 12,000 MHz to the
appropriate value.
EXAMPLE
SAT1 low
SAT1 high
OK
Initial auto installation
To Next Page
Loading...
