19
Daily operation
Turning on/standby the power
Turning on the power
Press < on the TV
or >a on the remote
control unit.
Standby mode
Press < on the TV or TV a on the remote
control unit when TV is on.
• The TV enters standby mode and the image on the
screen disappears.
• Weak electric power is still consumed even when the TV
is turned standby mode.
• To completely turn off the power to the TV, unplug the
AC cord from the AC outlet. However, do not unplug the
AC cord unless otherwise instructed.
NOTE
• If you are not going to use this TV for a long period of
time, be sure to remove the AC cord from the AC outlet.
Switching between digital, satellite*
and analogue broadcasts
Watching digital
broadcasts
Watching analogue
broadcasts
Watching satellite
broadcasts
*Important information:
Satellite services are only available for the 835 model
series.
NOTE
• If multiple satellite services are set, each time you press
the SAT button the channel switches as follows.
SAT1 SAT2
SAT3SAT4
Changing channels
With :r/s With 0_9
Selecting an external video source
Once the connection is made, press b to display
the “INPUT” screen, and then press b or a/b to
switch over to the appropriate external source with
;.
TV
INPUT
Switchable
CH list
NOTE
• You can also select an external video source from
“Menu” > “CH list” > “INPUT”.
• Only HDMI inputs which are not set for “Input skip”
(Page 43) and properly connected inputs can be selected.
Watching TV
To Next Page
Loading...
