Sharp AQUOS XU Series LC-70XU830X

To Next Page

To Previous Page

ControloftheTV

TheTVcanbecontrolledfromaPC,controlpanelsandotherdevices

usingtheRS-232C.

Useacross-typeRS-232Ccable(commerciallyavailable)forthe

connections.

NOTE

Thisoperationsystemshouldbeusedbyapersonwhoisaccustomedto

usingcomputers.

AQUOSRemoteControl

SetthisfunctionwhenoperatingtheTVfromequipmentconnectedbyLAN

orwirelessLAN.Toperformtheoperation,referto"TVSetup">"General".



RemoteControlApp

When"RemoteControlApp"isselected,"Change"willbehighlighted.Press

(ENTER).



DetailedSettings

Makethedetailedsettings(LoginID,password).

Followtheon-screeninstructionstoconfigurethesettings.

DeviceName

SetthenameoftheTVdisplayedonothernetworkdevices.

Configurethesettingsfrom"HOME">"Settings">"Device">"About">

"DeviceName".

CommunicationConditionsforRS-232C

SettheRS-232CcommunicationsettingsonthePCtomatchtheTV's

communicationconditions.

TheTV'scommunicationsettingsareasfollows:

Baudrate: 9,600bps

Datalength: 8bits

Paritybit: None

Stopbit: 1bit

Flowcontrol: None

Communicationprocedure

SendthecontrolcommandsfromthePCviatheRS-232C.

TheTVoperatesaccordingtothereceivedcommandandsendsaresponse

messagetothePC.

Donotsendmultiplecommandsatthesametime.

WaituntilthePCreceivestheOKresponsebeforesendingthenext

command.

UsingaPC

EN8-2

>><<

Sharp AQUOS XU Series LC-70XU830X - Control of the TV