28
MISFEED REMOVAL
When the misfeed ( ) indicator blinks or blinks in the display, the unit will
stop because of a misfeed.
1
Open the side cover, in that order.
To open the side cover, see "TONER CARTRIDGE REPLACEMENT"
(p.21).
2
Check the misfeed location. Remove the misfed paper
following the instructions for each location in the illustration
below. If the misfeed ( ) indicator blinks, proceed to "A:
Misfeed in the paper feed area" (p.29).
If paper is misfed here, proceed to "A:
Misfeed in the paper feed area". (p.29)
If paper is misfed here, proceed to "B:
Misfeed in the fusing area". (p.29)
If the misfed paper is seen from
this side, proceed to "C: Misfeed
in the transport area". (p.30)
AR-122EN_123E.book 28 ページ ２００２年８月７日 水曜日 午前８時５５分
To Next Page
Loading...
