In some areas, the “POWER” switch positions are marked “I” and
“ ” on the copier instead of “ON” and “OFF”.
The symbol “ ” denotes the copier is not completely de-energized
but in a stand-by condition at this “POWER” switch position.
If your copier is so marked, please read “I” for “ON” and “ ” for
“OFF”.
Caution!
For a complete electrical disconnection, pull out the main plug.
The socket-outlet shall be installed near the equipment and
shall be easily accessible.
The CE mark logo label is affixed on an equipment in case that the directives
described in the above sentence are applicable to the product. (This sentence is not
applicable in any country where the above directives are not required.)
Shielded cables must be used with this equipment to maintain compliance with
standards.
AR-122EN_123E.book 1 ページ ２００２年８月７日 水曜日 午前８時５５分
To Next Page
Loading...
