Main code Sub code Content
26 07 Machine conditions check
(Operation/Procedure)
When this simulation is executed, the current machine setting is displayed.
20 Rear edge void setup
(Operation/Procedure)
1. When this simulation is executed, the currently set code number of rear edge void setting is displayed.
2. Enter the code number of rear edge void setting and press the START key, and the setting will be changed.
30 CE mark conformity control ON/OFF setup
(Operation/Procedure)
1. When this simulation is executed, the currently set code number of CE mark application is displayed.
2. Enter the code number of CE mark application and press the START key, and the setting will be changed.
37 Cancel of stop at developer life over
When this simulation is executed, the current set code is displayed. Enter a new code and press the PRINT
switch, and the entered code is registered.
39 Memory capacity setup
(Operation/Procedure)
1. When this simulation is executed, the currently set code number is displayed.
2. Enter the code number and press the START key, and the setting will be changed.
40 Polygon motor OFF time setup
(Operation/Procedure)
1. When this simulation is executed, the currently set code number is displayed.
2. Enter the code number and press the START key, and the setting will be changed.
CPM Copy quantity display
10 cpm 10
12 cpm 12
15 cpm 15
The machine type is shown with the lamp display.
No setup: None
BTA-A: AE mode lamp ON
BTA-B: TEXT mode lamp ON
BTA-C: Photo mode lamp ON
Code number Rear edge void setting
0 Rear edge void allowed
1 Rear edge void not allowed
Code number CE mark application setting
0 CE mark application control OFF
1 CE mark application control ON
Code number Setting
0 Stop at developer life over
1 Stop cancel at developer life over
Code number Setting
0 No memory
1 4 Mbyte
2 6 Mbyte
Code number Setting
0 0 sec
1 30 sec
2 60 sec
3 90 sec
AR-F152
9 – 6
To Next Page
Loading...
