Sharp AR-215

Multi-Access Operation
8
Stopping a print job
A print job is normally stopped by changing to print mode and then changing the job to "Offline".
1
Press the JOB STATUS key. ( page 5)
2
Select "JOB OUTPUT" with the keys and then press the OK
key. ( page 6)
3
Select a job whose status is "PRINTING" or "PROCESSING" with
the keys and then press the OK key.
●
The display shows "Print data is cleared".
3) Receiving a fax manually
In Fax mode, faxes can be received manually by pressing the SPEAKER key and then the START
key. In cases where you cannot change to fax mode, you can initiate manual reception from the job
status menu. The procedure for manual reception in copy mode is explained here.
1
Lift the handset of the external phone.
2
Press the JOB STATUS key. ( page 5)
3
Select "MANUAL RECEIVING" with the keys and then press
the OK key.
●
Manual reception begins and "Fax is being received" appears in the display for two seconds.
4) Changing to a copy job during an auto print job
Use the following procedure to temporarily stop an auto print job and begin a copy job.
1
Press the COPY key.
●
If the machine is already in copy mode, go to step 2.
2
Enter the desired copy settings and then press the START key.
●
The auto print job temporarily stops and the copy job begins.
3
Resume the auto print job.
The auto print job will resume when any of the following takes place.
●
The CLEAR ALL key is pressed.
●
The PRINT key is pressed (if the interrupted job is a print job), or the FAX key is
pressed (if the interrupted job is a fax print job).
●
The preset time (time-out setting) elapses.
Notes
●
If the print job is a two-sided print job or a staple print job, the copy job is stored.
●
If a fax is received, it will be received to memory.
When printer priority mode is selected
When printer priority mode has been selected using the key operator program, a print job
cannot be interrupted by a copy job. If the START key is pressed, the copy job is stored
and "Copying will start after current print job is complete." appears in the display. The
copy job will start automatically after the print job is finished.
Downloaded from: http://www.usersmanualguide.com/