Main Sub
Item Content
Adjustment
code code range
25 03 Sets toner
control
ignorance time.
0-99SIMULATION NO.25- 3
TONER CONTROL MODE SETUP [XX]:_ [S]
(0~99)
INPUT SETUP VALUE AND PRESS PRINT SW
[Content] The toner control ignorance time at the rotation of the main motor can be set in the
range of 0 to 99 seconds.
The current setting is displayed and a new value can be set.
(a) Operation/display
[PRINT]: If the entered value is valid, the current setting is updated and the sub code
input screen is displayed. If the entered value is not valid, the input field is
cleared and the error buzzer sounds. If any value is not entered, the setting
remains unchanged and the sub code input screen is displayed.
[0-9]: Enters new settings
[C]: Clears the input field.
[PAUSE]: No setting is made and the sub code input screen is displayed.
[CA]: The execution of the simulation is stopped and the simulation is terminated.
26 Setting. SIMULATION NO.26-
1.OPTION UNIT SETUP
2.FOOLSCAP SETUP
3.COUNTER MODE SETUP
6.DESTINATION SETUP
15.FUSING CURL MODE SETTING
18.TONER SAVE MODE SETTING
26.POWER SAVE DESTINATION SETTING
27.IMAGE DENSITY MODE SETTING
INPUT SUB NO. AND PRESS PRINT SWITCH
9 – 46
To Next Page
Loading...
