Sharp AR-M350U

AR-M350 SIMULATIONS 10-1
[10] SIMULATIONS
1. Entering the simulation mode
Enter the copy mode and perform the following procedures.
[P] [*] [C] [*] [Main code] [START] [Sub code] [START]
2. Switching the simulation mode
Press [USER SETTING] to return to the code entry screen.
3. Canceling the simulation mode
Press CA key to cancel the simulation mode.
4. Simulation list
Code
Function (Content) Purpose Section Item
Main Sub
1 1 Used to check the operations of the scanner (reading) unit and
its control circuit.
Operation test, check Scanner (reading) Operation
2 Used to check the operations of the sensors and detectors in
the scanner (reading) unit and their control circuits.
Operation test, check Scanner (reading) Operation
2 1 Used to check the operations of the automatic document feeder
unit and its control circuit.
Operation test, check DSPF Operation
2 Used to check the operations of the sensors and detectors in
the automatic document feeder unit and their control circuits.
Operation test, check DSPF Operation
3 Used to check the operation under load in the automatic
document feeder unit and their control circuits.
Operation test, check DSPF Operation
3 2 Used to check the operations of the sensors and detectors in
the finisher and their control circuits.
Operation test, check Finisher Operation
3 Used to check the operation under load in the finisher and their
control circuits.
Operation test, check Finisher Operation
6 Used to adjust the stacking capacity of the finisher.
(Used to adjust the alignment plate (jogger) stop position in the
finisher paper width direction. The adjustment is made by
changing the alignment plate home position in the paper width
direction by software. )
Adjustment Finisher Operation
10 Used to adjust the console finisher (AR-FN7). Adjustment Finisher Operation
20 Used to check the mail bin stacker (AR-MS1) sensor. Operation test, check Mail bin stacker Operation
21 Used to check the operations of the mail bin stacker loads. Operation test, check Mail bin stacker Operation
4 2 Used to check the operations of the sensors and detectors in
the paper feed section (desk paper feed/large capacity trays)
and their control circuits.
Operation test, check Paper feed Operation
3 Used to check the operation under load in the paper feed
section (desk paper feed/large capacity trays) and their control
circuits.
Operation test, check Paper feed Operation
5 1 Used to check the operations of the lamps and LCD on the
operation panel and their control circuits.
Operation test, check Operation
(display, operation)
Operation
2 Used to check the operations of the heater lamp and its control
circuit.
Operation test, check Fusing Operation
3 Used to check the operations of the copy lamp and its control
circuit.
Operation test, check Scanner (reading) Operation
6 1 Used to check the operation under load (clutches and
solenoids) in the paper transport system and their control
circuits.
Operation test, check Paper transport
(paper exit,
switchback, transport)
Operation
2 Used to check the operations of each fan motor and its control
circuit.
Operation test, check Others Operation
7 1 Used to set the aging conditions. Setup Operation
6 Used to set the intermittent aging cycle. Setup Operation
8 Used to set Enable/Disable of warm-up time display. Setup Operation
      !"#$%&