Sharp AR-M350U

AR-M350 SIMULATIONS 10-9
5. Details of simulations
<List of set values>
<List of display value>
<List of set values>
<List of display values>
Main code 1
1-1
Purpose Operation test, check
Function (Content) Used to check the operations of the scanner
(reading) unit and its control circuit.
Section Scanner (reading)
Item Operation
Operation/Procedure Select with 10 digit key pad.
1 High speed operation 168mm / sec
2 Middle speed operation 110mm / sec
3 Low speed operation 55mm / sec
4 Top speed operation 220mm / sec
1-2
Purpose Operation test, check
Function (Content) Used to check the operations of the sensors and
detectors in the scanner (reading) unit and their
control circuits.
Section Scanner (reading)
Item Operation
Operation/Procedure The sensor display is highlighted when it is
detected.
MHPS Optical system home position
SIMULATION 1-1
SCANNER CHECK. SELECT 1-4, AND PRESS START.
1. HIGH SPEED
2. MIDDLE SPEED
3. LOW SPEED
4. TOP SPEED
1
SIMULATION 1-1
SCANNER CHECK. EXECUTING...
1. HIGH SPEED
2. MIDDLE SPEED
3. LOW SPEED
4. TOP SPEED
1
Press [START] key to get started.
Press [CUSTOM SETTING] key to stop.
Stops when scan is completed.
SIMULATION 1-2
SCANNER SENSOR CHECK..
MHPS
Main code 2
2-1
Purpose Operation test, check
Function (Content) Used to check the operations of the automatic
document feeder unit and its control circuit.
Section DSPF
Item Operation
Operation/Procedure Select with 10 digit key pad.
1 High speed operation
2 Low speed operation
2-2
Purpose Operation test, check
Function (Content) Used to check the operations of the sensors and
detectors in the automatic document feeder unit
and their control circuits.
Section DSPF
Item Operation
Operation/Procedure The sensor display is highlighted when it is
detected.
SSET SPF sensor
SOCD Open sensor
SCOV Paper feed cover sensor
SDD Document set sensor
SPSD Document resist front sensor
SPCD Document exit sensor
SWDn Document width sensor (n 1(Inside) ~6(Outside))
SLDn Document length sensor (n 1(Inside) ~2(Outside))
OSSET OS installation sensor
STSET Stamp unit installation sensor
SWD_LEN SPF guide plate position (Unit: 0.1mm)
SWD_AD SPF document width detection volume output AD value
SIMULATION 2-1
SPF AGING TEST. SELECT 1-2, AND PRESS START.
1. HIGH SPEED
2. LOW SPEED
2
SIMULATION 2-1
SPF AGING TEST. EXECUTING...
1. HIGH SPEED
2. LOW SPEED
2
Press [START] key to get started.
Press [CUSTOM SETTING] key to stop.
SIMULATION 2-2
SPF SENSOR CHECK.
SSET SOCD SCOV SDD
SPSD SPOD SWD6 SWD5
SWD4 SWD3 SWD2 SWD1
SLD2 SLD1 CISSET STSET
SWD_LEN: 2100 SWD_AD: 600
 SDD
SPSD SPOD SWD5
SWD4 SWD3 SWD2 SWD1
SLD2 SLD1 STSET
SWD_LEN: SWD_AD:
 -     !"#$%&