Sharp AR-M350U

AR-M350 SIMULATIONS 10-5
46 2 Used to adjust the copy density in the copy mode
(binary, auto, text, text/photo, photo mode).
An adjustment with this simulation affects all the copy density
adjustment values.
Adjustment Picture
quality
Density
9 Used to adjust the print density for each density level
(display value) in the copy mode (binary-Text mode).
A desired print density can be set for each density level
(display value).
Adjustment Picture
quality
Density
10 Used to adjust the print density for each density level
(display value) in the copy mode (binary-Text/Photo mode).
A desired print density can be set for each density level
(display value).
Adjustment Picture
quality
Density
11 Used to adjust the print density for each density level
(display value) in the copy mode (binary-Photo mode).
A desired print density can be set for each density level
(display value).
Adjustment Picture
quality
12 Used to adjust the print density in the FAX mode (all modes).
An adjustment with this simulation affects all the copy density
adjustment values. (Only when FAX is installed)
Adjustment Picture
quality
13 Used to adjust the print density in the FAX mode
(normal mode). (Only when FAX is installed.)
Adjustment Picture
quality
14 Used to adjust the print density in the FAX mode
(small text mode). (Only when FAX is installed.)
Adjustment Picture
quality
15 Used to adjust the print density in the FAX mode (fine mode).
(Only when FAX is installed.)
Adjustment Picture
quality
16 Used to adjust the print density in the FAX mode
(super-fine mode). (Only when FAX is installed.)
Adjustment Picture
quality
17 Used to adjust the CCD/CIS shading reference value. Setup, check Picture
quality
18 Used to adjust gamma (density gradient) in each copy mode. Adjustment Picture
quality
Density
19 Used to adjust gamma (density gradient) in the auto copy mode
and to set the density detection area, and to set the image
process mode.
Adjustment Picture
quality
Density
20 Used to adjust the copy density correction in the SPF/DSPF
copy mode for the document table copy mode. This adjustment
is made so that the copy density becomes the same as that in
the document table copy mode.
Adjustment Picture
quality
Density
21 Used to adjust the scanner exposure level.
(1 mode auto adjustment)
Adjustment, setup,
operation data output,
check (display)
Scanner (reading) Picture
quality
Density
22 Used to adjust the scanner exposure level and to make
individual setup. (Normal mode)
Adjustment, setup,
operation data output,
check (display)
Scanner (reading) Picture
quality
Density
23 Used to adjust the scanner exposure level and to make
individual setup. (Small text mode)
Adjustment, setup,
operation data output,
check (display)
Scanner (reading) Picture
quality
Density
24 Used to adjust the scanner exposure level and to make
individual setup. (Fine mode)
Adjustment, setup,
operation data output,
check (display)
Scanner (reading) Picture
quality
Density
25 Used to adjust the scanner exposure level and to make
individual setup. (Super fine mode)
Adjustment, setup,
operation data output,
check (display)
Scanner (reading) Picture
quality
Density
48 1 Used to adjust the copy magnification ratio
(main scan direction, sub scan direction).
Adjustment Scanner (reading) Picture
quality
5 Used to adjust the scan motor speed. Adjustment Scanner (reading) Picture
quality
Code
Function (Content) Purpose Section Item
Main Sub
 )     !"#$%&