AR-M350 SIMULATIONS 10-4
26 41 Used to set Enable/Disable of the magnification ratio auto
selection function (AMS) in the pamphlet copy mode.
Setup Spec Operation
mode
(Common
operation)
52 Used to set Enable/Disable of count-up when white paper is
discharged. (White paper means the index paper
(without copying) in the OHP index paper insertion mode,
the front/rear covers (without copying) in the cover insertion
mode, and white paper in the duplex exit mode (CA, etc.).)
Setup Paper transport
(Paper exit,
switchback, transport)
27 1 Used to set the operation specifications when a communication
trouble occurs between the host computer and MODEM
(machine side). (When a communication trouble occurs
between the host computer and MODEM (machine side), self
diag display (U7-00) is displayed and setup is made to inhibit or
allow printing. )
Setup Communication
(RIC/MODEM)
Spec Operation
mode
(Common
operation)
5 Used to enter the machine tag No. (This function allows to
check the machine tag No. from the computer.)
Setup Communication
(RIC/MODEM)
Data
30 1 Used to check the operations of the sensors and detectors in
the paper feed, paper transport, and paper exit sections and
their control circuits.
Operation test, check Operation
2 Used to check the operations of the sensors and detectors in
the paper feed section and their control circuits.
(The operations of the sensors and detectors in the paper feed
section can be monitored on the LCD display.)
Operation test, check Paper feed Operation
40 1 Used to check the operations of the manual paper feed tray
paper size detectors and their control circuit.
(The operations of the manual paper feed tray paper size
detectors can be monitored on the LCD display.)
Operation test, check Paper feed Operation
2 Used to adjust the detection level of the manual paper feed tray
paper width detector.
Adjustment Paper feed Operation
7 Used to enter the adjustment value of the manual paper feed
tray width detection level.
Adjustment, setup Paper feed Operation
11 Used to check the width detection level of the multi purpose
tray paper width detector.
Operation test, check Paper feed Operation
12 Used to adjust the width detection level of the multi purpose
tray paper width detector.
Adjustment, setup Paper feed Operation
41 1 Used to check the operations of the document size sensor and
the related circuit. (The operation of the document size sensor
can be monitored on the LCD display.)
Operation test, check Other Operation
2 Used to adjust the detection level of the document size sensor. Adjustment Other Operation
3 Used to check the operations of the document size sensor and
the related circuit. (The output level of the document size
sensor can be monitored on the LCD display.)
Operation test, check Other Operation
43 1 Used to set the fusing temperature in each operation mode. Setup Fusing, paper exit
44 1 Used to set Enable/Disable of each correction operation in the
image forming (process) section.
Setup Process (OPC drum,
developing, transfer,
cleaning)
Operation
4 Used to set the target image (reference) density level in the
developing bias voltage correction.
Setup Process (OPC drum,
developing, transfer,
cleaning)
Data
9 Used to check the result (main charger grid voltage developing
bias voltage, laser power, etc.) of correction
(process correction) in the image forming section.
(By this simulation, the correction operation can be checked.)
Adjustment, setup,
operation data output,
check (display, print)
Process (OPC drum,
developing, transfer,
cleaning)
Data Operation
data
(machine
condition)
Code
Function (Content) Purpose Section Item
Main Sub
( !"#$%&
To Next Page
Loading...
