ENTERING CHARACTERS
7-27
7
■
■■
■ Entering numbers and symbols
1
Touch the [AB/ab 12#$%] key.
When the characters "12#$%" are highlighted,
number/symbol entry mode is selected.
2
Enter the desired number or symbol.
Numbers and symbols that can be entered are as
follows:
Screen 1/2
Screen 2/2
* Change screens by touching the key or
key displayed in the screen. If you make a
mistake, touch the key to move the cursor
( ) back one space and then enter the correct
character.
You can continue touching keys to enter
characters. You can also touch another
character type selection key ([ ÃÄÂ/ãäâ] key
or [AB/ab 12#$%] key) to enter characters
other than numbers and symbols.
3
When you have finished entering
characters, touch the [OK] key.
You will exit the character entry screen and return
to the programming screen. If you touch the
[CANCEL] key, you will return to the programming
screen without storing the entered characters.
NOTE
The following symbols cannot be used when
entering a file name or folder name.
1&1
:::
\?/"; :,
<> ! * |&#
To Next Page
Loading...
