Sharp AX-1100R Service Manual

AX1100(R)
8 – 2
ENERGY SAVE
MODE
OFF
CONDITION
COOKING
CONDITION
(COMMON MODE)
MICROWAVE
COOKING
GRILL COOKING
CONDITION
COMBI
COOKING
STEAM
COOKING
CONDITION PROBLEM
INPUT TIME IS OVER MAXIMUM COOKING TIME TEMPERATURE OF ENGINE UNIT IS TOO HIGH. TUBES ARE CHOKED. TEMPERATURE OF OVEN IS TOO HGIH. WATER TANK IS EMPTY. WATER IS FROZEN IN WATER TANK OR TUBE27/2#55'/$.; TEMPERATURE OF OVEN IS TOO HIGH IN MICROWAVE COOOKING. HOME FUSE OR BREAKER NO POWER AR WALL OUTLET BLOCKED COOLING FAN BLOCKED VENTILATION OPENINGS MIS-ADJUSTMENT OF SWITCHES OPENED WIRE HARNESS SHORTED WIRE HARNESS POWER SUPPLY CORD KEY UNIT (MEMBRANE SWITCH) CONTROL UNIT ENGINE UNIT (ENGINE HEATING ELEMENT) GRILL HEATING ELEMENT OVEN LAMP INTAKE DAMPER MOTOR FAN MOTOR PUMP MOTOR ANTENNA MOTOR NOISE FILTER FUSE F8A F2 FUSE 20A F1 ENGINE THERMAL CUT-OUT TC3 OVEN THERMAL CUT-OUT TC2 MG THERMAL CUT-OUT TC1 THERMISTOR (GRILL) TH2 THERMISTOR (ENGINE) TH1 ANTENNA SWITCH SW5 DOOR SENSING SWITCH SW3 MONITOR SWITCH SW2 MONITORED INTERLOCK SWITCH SW1 HIGH VOLTAGE CAPACITOR H.V. RECTIFIER ASSEMBLY HIGH VOLTAGE TRANSFORMER MAGNETRON
ABCDEEE
INTAKE DAMPER SWITCH SW4
EEGGHHH I JK L L MN
TEST PROCEDURE
POSSIBLE CAUSE
AND
DEFECTIVE PARTS
Home fuse or breaker blows when power supply cord is plugged
into wall outlet.
Nothing appears in display when power supply cord is plugged into
wall outlet and the door is open and closed.
Fuse 20A F1 blows when power supply cord is plugged into wall
outlet.
Fuse 20A F2 blows when the door is opened.
Display does not operate properly when the stop key is pressed.
Oven lamp does not light when the door is opened.
(Display operates.)
Oven does not start when the START key is pressed.
(Display operates.)
Oven lamp does not light.
Fan motor does not operate.
Oven stops 1minute after STARTkey is pressed.
Oven seems to be operating but little or no heat is produced in oven
load. (Microwave power control is set at HIGH.)
Oven does not seem to be operating properly during variable
cooking condition except HIGH cooking condition.
Oven goes into cook cycle but shuts down before end of cooking
cycle.
Grill heating element does not operate.
Oven goes into cook cycle but shuts down before end of cooking
cycle.
Oven seems to be operating but little or no heat is produced in
oven load. (Microwave power control is set at HIGH.)
Grill heating element does not operate.
Engine unit does not operate.
Pump motor does not operate.
Intake damper does not close.
Oven goes into cook cycle but shuts down before end of cooking
cycle.
"Err" AND "HOT" is displayed.
"Err"is displayed.
"Err" AND "WATER" is displayed.
"EE01" is displayed.
"EE05"is displayed.
"EE07" is dislayed.
"EE12" is displayed.
"EE14" is displayed.
"RESET" is displayed.

Sharp AX-1100R Specifications

General

Brand	Sharp
Model	AX-1100R
Category	Microwave Oven
Language	English