Sharp AY-XPM9FR - Airflow Direction Control; Vertical Louver Adjustment

GB-10
ADJUSTING THE AIR FLOW DIRECTION
VERTICAL AIR FLOW DIRECTION
COOL and DRY modes
HEAT mode
The adjustment range
is narrower the SWING
range in order to pre-
vent condensation from
dripping.
The range is wide and
air fl ow can be directed
toward the fl oor.
Hold the horizontal adjustment
louvre as shown in the diagram
and adjust the air fl ow direction.
Press the SWING button on the re-
mote control once.
• The vertical adjustment louvres will
swing.
Press the SWING button again
when the vertical adjustment lou-
vres are at the desired position.
• The louvre will stop moving within
the range shown in the diagram.
• The adjusted position will be memo-
rized and will be automatically set
to the same position when operated
the next time.
Adjustment range
CAUTION
Never attempt to adjust the vertical adjustment louvres manually.
• Manual adjustment of the vertical adjustment louvre can cause the unit to malfunction when the
remote control is used for adjustment.
• When the vertical adjustment louvre is positioned at the lowest position in the COOL or DRY
mode for an extended period of time, condensation may result.
Do not adjust the horizontal adjustment louvre to the extreme left or right in the COOL mode with
the fan speed set to “SOFT (
)” for an extended period of time.
Condensation may form on the louvres.
HORIZONTAL AIR FLOW DIRECTION
AY-XPM7912FR.indbGB-10AY-XPM7912FR.indbGB-10 2010/04/279:03:242010/04/279:03:24