OPERATION MANUAL

FOR YOUR RECORDS

For your assistance in reporting this unit in case of loss

or theft, please record below the model number and serial

number which are located on the rear of the unit.

Please retain this information.

Model number _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Serial number _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Date of purchase _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Place of purchase _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

MODEL

CD-BA200

HK <P=001>

MINI COMPONENT SYSTEM

Thank you for purchasing this SHARP product.

To obtain the best performance from this product,

please read this manual carefully.

It will guide you in operating your SHARP product.

CD-BA200 Mini Component System consisting of

CD-BA200 (main unit) and CP-BA200 (speaker system).

Note:

This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harm-

ful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a par-

ticular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the inter-

ference by one or more of the following measures:

●Reorient or relocate the receiving antenna.

●Increase the separation between the equipment and receiver.

●Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

●Consult the dealer or an experienced radio/TV technician for help.

WARNING

FCC Regulations state that any unauthorized changes or modifications

to this equipment not expressly approved by the manufacturer could void

the user’s authority to operate this equipment.

CAUTION

RISK OF

ELECTRIC

SHOCK

NOT

OPEN

The lightning flash with arrowhead

symbol, within an equilateral triangle,

is intended to alert the user to the

presence of uninsulated "dangerous

voltage" within the product’s enclosure

that may be of sufficient magnitude to

constitute a risk of electric shock to

persons.

CAUTION: TO REDUCE THE

RISK OF ELECTRIC SHOCK, DO

NOT REMOVE COVER (OR

BACK).

NO USER-SERVICEABLE PARTS

INSIDE. REFER SERVICING TO

QUALIFIED SERVICE PERSON-

NEL.

The exclamation point within an equi-

lateral triangle is intended to alert the

user to the presence of important

operating and maintenance (servic-

ing) instructions in the literature ac-

companying the appliance.

Caution - use of controls or adjustments or per-

formance of procedures other than those specified

herein may result in hazardous radiation exposure.

WARNING: TO REDUCE THE RISK OF

FIRE OR ELECTRIC SHOCK, DO NOT EX-

POSE THIS APPLIANCE TO RAIN OR

MOISTURE.

Note:

● It is the intent of Sharp that this product be used in

full compliance with the copyright laws of the United

States and that prior permission be obtained from co-

pyright owners whenever necessary.

CD-BA200(SEC) TINSE0276AWZZ

Sharp CD-BA200 - Page 58

Table of Contents

Other manuals for Sharp CD-BA200

Related product manuals