E-17
Enhancing your system
The connection cord is not included. Purchase a commer-
cially available cord as shown below.
Audio cable (not supplied)
Portable audio
player, etc.
■ Listening to the playback sounds of
portable audio player, etc.
1 Use a connection cord to connect the portable audio
player, etc. to the AUDIO IN jack.
2 Press the
(ON/STANDBY)
button to turn the power on.
3 Press the INPUT (AUDIO/LINE (INPUT)) button (main
unit or remote control) repeatedly to select AUDIO IN
function.
4 Play the connected equipment. If volume level of the
connected device is too high, sound distortion may
occur. Should this happen, adjust the volume of the
connected device.
Note:
To prevent noise interference, place the unit away from
the television.
■ Headphones
● Do not set the volume on to maximum at switch on.
Excessive sound pressure from earphones and head-
phones can cause hearing loss.
● Before plugging in or unplugging the headphone, re-
duce the volume.
● Be sure your headphone has a 1/8” (3.5mm) diameter
plug and impedance between 16 and 50 ohms. The
recommended impedance is 32 ohms.
● Plugging in the headphone disconnects the speakers au-
tomatically.
Troubleshooting chart
If something is wrong with this product, check the following be-
fore calling your authorized SHARP dealer or service center.
■ General
Symptom Possible cause
● The clock is not set to
the correct time.
● A power failure occurred.
Reset the clock. (Refer
page 8)
● When a button is
pressed, the unit does
not respond.
● Set the unit to the power
standby mode and then
turn it back on.
● If the unit still malfunc-
tions, reset it. (Refer page
18)
● No sound is heard. ● The volume level set to
“Volume Min”.
● The headphones are con-
nected.
■ Remote control
Symptom Possible cause
● The remote control
does not operate.
● The AC power cord of the
unit is not plugged in.
● The battery polarity is
wrong.
● The batteries are dead.
● The distance or angle is
incorrect.
● The remote control sensor
receives strong light.
■ Tuner
Symptom Possible cause
● The radio makes
unusual noises
continuously.
● The unit placed near a TV or
computer.
● The FM/AM antenna is not
placed properly. Move the
antenna away from the AC
power cord if it is located
nearby.
■ Bluetooth
Symptom Possible cause
● No sound is heard. ● The unit is too far from the
Bluetooth audio source
device.
● The unit is not paired
with the Bluetooth audio
source device.
● Bluetooth sound is in-
terrupted or distorted.
● The unit is too near to
a device that generates
electromagnetic radiation.
● There is an obstacle
between the unit and the
Bluetooth audio source
device.
To Next Page
Loading...
Need help?
General
