Sharp CD-DD4500 - Dubbing from Tape to Tape

27
CD-DD4500
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
You can record from TAPE 1 to TAPE 2.
For recording, use only normal tapes. Do not use metal and CrO2 tapes.
1 Press the POWER button to turn the power on.
2 Load a prerecorded cassette into the TAPE 1 cassette compart-
ment. Insert a blank tape into the TAPE 2 cassette compartment.
It is recommended that the recording tape be the same length as the master
tape.
3 Press the TAPE (1
VV
VV
V 2) button until “TAPE 1” appears in the
display.
4 Press the REC PAUSE
I6 I6
I6 I6
I6 (
I6I6
I6I6
I6) button.
Recording will be paused.
5 Press the
00
00
0 /
RR
RR
R (
0 0
0 0
0 ) button to start dubbing.
To stop dubbing:
Press the ■ (TAPE ■) button.
TAPE 1 and TAPE 2 will simultaneously stop.
Erasing recorded tapes
1. Load the tape to be erased into the TAPE 2 cassette compartment.
2. Press the TAPE (1 V 2) button until “TAPE 2” appears in the display.
3. Press the REC PAUSE I6 (I6) button. (“ERASE” will appears.)
4. Press the 0 / R ( 0 ) button to start erasing.
Note:
Make sure that the TAPE 1 is not in use.
Tape Recording
– Dubbing from Tape to Tape –
Dubbing from Tape to Tape